MicroE Systems Mercury 1000 Manual de instalación descargar pdf (Pagina 8)

Installation Instructions

Rotary Encoders

Attach your hub/scale

assembly to the rotary

device. Refer to the

interface drawing. The

reflective surface of the

scale must face the sensor.

1

Page 6

4

Be sure the source power is off

before connecting the

SmartSignal plug.

Connect the SmartSignal electronics

to the controller using pinout

diagram described on the

interface drawing.

Insure proper system grounding.

Refer to the procedure on pg 9.

Tighten the thumb screws.

Power up the system. The

Power/Calibration indicator will

illuminate.

2

3

CAUTION: observe precautions for handling

electrostatic sensitive devices.

Route the sensor cable through your equipment

to the SmartSignal electronics.

A) Remove the three cover screws and the top

half of the connector housing. Do not pull on

the 15-pin D-sub connector or the circuit

board under the insulation layer.

B) Attach the sensor's 5 X 2 connector to the

mating 5 X 2 connector on the circuit board.

C) Route the sensor cable through its channel

in the center of the connector body and place

the cable's hex sleeve in the matching recess.

Attach the top half of the connector housing

to the bottom half using the three cover screws.

The longest screw is used in the hole adjacent

to the cable exit.

Install the sensor on your mounting surface

referencing the appropriate datum surface as

shown on the interface drawing. Use 2 washers

per mounting screw.

Benching pins may be used to locate the sensor

if the system mechanical tolerances are adequate.

See data sheet for alignment tolerances, or keep

mounting screws loose for sensor alignment if

benching pins are not used.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comentarios a estos manuales

Sin comentarios